diff options
| -rw-r--r-- | runtime/tutor.txt | 37 |
1 files changed, 32 insertions, 5 deletions
diff --git a/runtime/tutor.txt b/runtime/tutor.txt index 5f3a0a7e..b2a64694 100644 --- a/runtime/tutor.txt +++ b/runtime/tutor.txt @@ -313,7 +313,7 @@ _________________________________________________________________ Type v to enter Select mode. Type v again or <ESC> to return to Normal mode In Select mode every movement will extend the selection, as - oppposed to replacing it. + opposed to replacing it. 1. Move the cursor to the line below marked -->. 2. Move to the F of FOO and type v2w to select the two words. @@ -985,11 +985,11 @@ lines. --> How much would would a wouldchuck chuck --> if a wouldchuck could chuck would? - Note: A-( and A-) cycle the *contents* of the selections - as well as the position of the primary selection. + Note: Additionally, A-( and A-) cycle the *contents* of the + selections as well. ================================================================= -= 10.3 CHANGING CASE = += 10.2 CHANGING CASE = ================================================================= Type ~ to switch the case of all selected letters. @@ -1011,13 +1011,40 @@ lines. --> THIS sentence should ALL BE IN uppercase! ================================================================= += 10.3 SPLITTING SELECTIONS = +================================================================= + + Type S to split each selection on a regex pattern. + + 1. Move the cursor to the line under ---. + 2. Type xx / 2x to select the lines. + 3. Type S then \.|!<enter>. This effectively splits the + selection into sentences at each dot or exclamation mark. + 4. Type A-; to reverse the selections. + 5. Type ; to reduce selections to a single character - the first + letter of each sentence. + 6. Type A-` to convert all selected letters to uppercase. + +--- +these are sentences. some sentences don't start with uppercase +letters! that is not good grammar. you can fix this. + + + + +================================================================= = CHAPTER 10 RECAP = ================================================================= + * Use ) and ( to cycle the primary selection back and forward + through selections respectively. + * Type A-, to remove the primary selection. + * Type ~ to alternate case of selected letters. - * Use ` and alt-` to set the case of selected letters to + * Use ` and A-` to set the case of selected letters to upper and lower respectively. + * Type S to split selections on regex. |